![]() ![]() vJoy Devices for the joystick selection and then click Properties. You should be able to find it with Windows Search. You can check you vJoy/UCR settings with joy.cpl (Windows Joystick Control Panel). Don't forget to save your configuration after making changes!įor the rest of the vJoy buttons (including the D-pad), you will need to use multiple ButtonToButton plugins. Axis 1 (X), Axis 2 (Y) and Axis 3 (Z)/ Axis 6 (Rz) worked for this example. You may need to experiment with the Axis settings in each plugin configuration, but the Axis settings themselves should all be for the same joystick (e.g. Set the Low and High values of the second ButtonToAxis to W and S respectively. Set the Low and High values of the first ButtonToAxis to A and D respectively. These are added one at a time with the Plugin Selection dropdown and Add near the top of the UCR interface. The new profile name should be reflected in the Current Profile field near the top of the main UCR window (left-hand pane).įrom there, you will need to add the following plugins to the main UCR interface: Once UCR restarts, in the Profile ToolBox section (right-hand pane) Add a new profile and make certain it is highlighted. Wait for the command window to close and UCR to restart automatically. As with the original vJoy driver installation, be patient. This will open a command window that installs SCPVBus. Use IOClasses → vJoy → Install SCPVBus (Will Restart UCR) to install SCPVBus. Note the line that says SCPVBus is not installed (Non fatal). ![]() You should see a pop up that looks similar to the following: On your first run, ensure that vJoy was loaded correctly by opening IOClasses → vJoy → Show vJoy Log from the main UCR menu bar. Place it somewhere where you will be comfortable keeping it (it doesn't have an installer). 1903), you may want to look at these forked Github project releases, specifically the one marked as v2.1.9.1.ĭownload and unzip UCR. If you have a later version of Windows 10 (i.e. This version supports up through Windows 10 1803. The instructions below use GitHub release version v2.1.8 Build 39 from the official vJoy GitHub repo. The installer may take a few minutes to fully complete. Don't worry about any of the optional install items (i.e. VJoy is a "virtual" (software-only) joystick and UCR is an application built with AutoHotkey that allows you to map keyboard and mouse input to vJoystick controls.ĭownload and install vJoy ( vJoySetup.exe). You may want to have a look at vJoy and Universal Control Remapper (UCR). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |